![]() ![]() Please contact the dealership where you purchased your car to see if your vehicle contains any of these features. Also, the following glass features may interfere with the E-ZPass signal and require alternative or exterior mounting: solar ray, solar tint, heated, heat reflected, insulated, Insta-Clear. In general, windshields that contain metal in the glass (metal oxide) and mirrors with compass or temperature readings may prevent the E-ZPass signal from being read properly. Some vehicles have special features that require an exterior License Plate Tag (LPT) or alternative placement. Mounting for Vehicles with Special Windshield Features Please note: Your E-ZPass license plate tag should be attached to the center of the front bumper, even if your license plate is in a different location. ![]() Tighten the bolts securely, but do not over tighten. Fasten your E-ZPass tag to the front license plate using the existing top mounting bolts and the knock-out holes at the bottom of the E-ZPass tag, so you do not cover the state name on your license plate. You can order them (for free) directly from the ezpass website.This side should face inward to your vehicle. 1.99 fee applies for each payment transaction. Cash or Credit/Debit cards are accepted at any of our Customer Service Centers. It will have the sticker with the Maine Turnpike Logo. Mail a check to the EZDriveMA Customer Service Center, 27 Midstate Drive, Auburn, MA 01501. Identify the flat side of your E-ZPass tag.You may order additional mounting strips by calling E-ZPass Customer Service atġ-888-MTA-PASS (1-88), Mon-Fri, 8 AM-6 PM An extra set of mounting strips was provided with your E-ZPass order. If you can find a lane with an attendant, they will give you one. Or just ask an employee, they likely get these questions a lot and know what to get. Hardware stores typically sell a 3M product that is very similar. Please note: Do not try to remove the mounting strips from your windshield and reuse them. Why don’t you get the one that goes on your license plate it’s only 10 dollars.Your E-ZPass tag may be removed by gently lifting one corner of the tag to separate the adhesive strips.Place the tag in the correct position and press firmly against the glass for 15 seconds to achieve a good bond. Turn the tag right side up facing you.Without removing the second set of adhesive strips from the tag, carefully remove the protective backing from the mounting strips on the rear of the tag. There are four adhesive strips: two are permanently mounted to the tag, and two are for mounting to the windshield.If your vehicle has tinted glass, make sure the device is at least 1 inch below the tinted section of glass. Locate the correct position for the tag - the upper center portion of your windshield behind the rearview mirror, at least 1 inch to the right of the mirror and at least 1 inch below the top edge of the windshield.This side faces the interior of the vehicle with the arrows on the tag pointing toward the roof. Identify the front face of your E-ZPass tag (it will have the label with the Maine Turnpike Logo and the tag serial number).Clean and dry the inside of your windshield around the rearview mirror.Vehicles with Special Windshield features.Standard windshield and license plate mounts. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |